中文简体
عربى
1、Disconnect the power supply first;
2、Use a screwdriver to loosen the left screw;
3、Use a screwdriver to loosen the screw on the right side;
4、Reach inside the gap between the top cover and the outer barrel and use your fingers to open the front cover on the left and right sides;
5、Then take the front cover off;
6、loosen the three screws on the rear cover of the washing machine;
7、Take out the rear cover;
8、unscrew the screws inside the four corner holes;
9、loosen the screws of the back cover, open the back cover;
10、Take the top cover up and place it against the chair;
11、Loosen the four screws on the top of the outer bucket cover;
12、After removing the outer bucket cover, unscrew the screw in the middle of the bobbin;
13、Loosen the screws and unscrew the bobbin;
14、Unscrew the large nut with a tool and you can put the reducer on.
.png?imageView2/2/format/jp2 "123(30-25)")
.png?imageView2/2/format/jp2 "151(22-18)")
.png?imageView2/2/format/jp2 "164(26-23)")
.png?imageView2/2/format/jp2 "167 bushing(11Z 28-25)")
.png?imageView2/2/format/jp2 "169(30-25)")
.png?imageView2/2/format/jp2 "169 bushing(11Z 30-25)")
.png?imageView2/2/format/jp2 "170(11Z35-30)")
.png?imageView2/2/format/jp2 "171(11Z 40-35)")
